Unidirectional Kevlar Tape 280gsm 100mm
Unidirectional Kevlar tape 280gsm 100mm is a narrow-width aramid reinforcement with all fibres running along its length. It suits jobs that need only a strip, such as reinforcing tubes, spars, edges and seams where impact and abrasion resistance matter. Kevlar is tough and light, and it is not conductive. Sold in lineal metres.
At a glance
| Spec | Value |
|---|---|
| Fibre | Kevlar (aramid), unidirectional |
| Areal weight | 280gsm (280g per m² dry) |
| Width | 100mm |
| Weight per metre | about 28g (calculated) |
| Cured thickness per layer | About 0.25mm (indicative) |
| Colour | Yellow |
| Resin compatibility | All resins |
| Sold as | Per lineal metre |
Why choose unidirectional Kevlar tape 280gsm?
Fibre where the load is
All the fibre runs one way, so a layer along a beam, tube or spar adds tensile strength in that direction. It is weak across the fibres, so cross it with other layers where needed.
Kevlar versus carbon and glass
Kevlar is very strong in tension and resists impact, abrasion and cut-through better than carbon or glass. It is less stiff than carbon and weaker in compression. Use it where toughness matters more than stiffness. Check the supplier’s data for figures, because I have none for this product.
Tape or fabric?
Tape suits narrow strips, joints and local reinforcement with little waste. Wide fabric suits skins and panels.
Where unidirectional Kevlar tape fits
Buy this, or buy the neighbour
- Choose our carbon fibre tape when you need maximum stiffness.
- Choose our basalt tape for a balance of strength and cost.
- Choose our fibreglass tape for the lowest cost.
Worked example
Three metres of tape weighs about 84g dry. Two layers over a 3m seam add about 168g dry and roughly 0.5mm along the join. Indicative only.
Using the tape
Suits wet layup, vacuum bagging and infusion, and it is compatible with all resins. Kevlar is hard to cut, so use sharp aramid shears and tape the cut line to limit fraying. Wear gloves and a dust mask. See our adhesives and resins range.
Applications
Unidirectional Kevlar tape 280gsm suits these jobs.
- Tube and pipe reinforcement: wrapping and impact protection
- Edges and seams: abrasion-resistant bridging
- Marine and boat repair: hull and keel reinforcement
- Protective parts: impact-prone areas
- Non-conductive reinforcement: parts near electrical equipment
Specifications
| Property | Specification |
|---|---|
| Fibre | Kevlar (aramid) |
| Construction | Unidirectional |
| Areal weight | 280gsm |
| Width | 100mm |
| Weight per metre | about 28g (calculated) |
| Cured thickness per layer | About 0.25mm (indicative) |
| Resin compatibility | All resins |
| Sold as | Per lineal metre |
Unidirectional Kevlar tape 280gsm: frequently asked questions
Is Kevlar stronger than carbon?
In tension and impact toughness, it can be, but carbon is much stiffer. Choose by what the part needs.
Which resins can I use?
All resins.
How is it sold?
By the lineal metre, in a 100mm width.








